Introduce the use of the coding ribbon slitting machine

The coding ribbon slitting machine is mainly used to accurately cut the ribbon material into the required width to meet different printing needs. The following is how to use the coding ribbon slitting machine:

First, preparation before starting

1. Check the equipment:

• Make sure the power, air pressure, hydraulics and other systems of the slitter are in normal condition.

• Check whether the parts are in good condition and replace them in time if damaged.

2. Power on:

• Turn on the electrical isolation switch and check whether the voltage and current are stable.

• Turn on the power switch of the hydraulic system and check whether the oil level and pressure gauge display are correct.

• Open the pneumatic shut-off valve and check whether the air pressure is stable.

Second, set the slitting parameters

1. Set up the slitting menu:

• Set the slitting menu according to the type, thickness, length, width and other requirements of the coded ribbon.

2. Extract the film file:

• Extract film archives from device storage that match the current ribbon.

3. Set the winding length and width:

• Set the winding length and width of the ribbon according to your needs.

4. Select the winding station:

• Adjust the roller arm and roller, install the paper core of the corresponding specification, and select the appropriate winding station.

Third, feeding and film wearing

1. Feeding:

• According to the requirements of the slitting plan, lift the corresponding parent roll and put it on the unwinding rack of the slitting machine.

• Clamp the steel core with the control buttons and secure the parent coil.

2. Penetration:

• When there is no film on the slitting machine, the film piercing operation is required.

• Tie one end of the original film to the ring eye of the film threading chain, activate the threading button, and distribute the film on each roller along the slitting process.

Fourth, start-up operation and slitting control

1. Boot up and run:

• Notify all personnel to leave the machine to ensure safety.

• Put the relevant button on the main operator station into automatic mode to start the machine running.

2. Slitting control:

• During the slitting operation, carefully monitor and observe the slitting effect.

• Appropriate adjustment and control of slitting speed, unwinding tension, contact pressure, arc roller, edge material traction roller, guide edge, etc.

Fifth, receiving and parking

1. Receiving:

• When the machine stops running after the inner and outer end winding is completed, use the film unloading button to place the film on the prepared film unloading trolley.

• Cut the film and paste the roll with sealing glue to ensure that the roll is neat and wrinkle-free.

2. Parking:

• When the roll runs to a set length, the machine automatically stops.

• If you need to stop in an emergency during the operation of the equipment, you can press the emergency stop button.

Sixth, precautions

1. Safe Operation:

• Before starting and during operation, ensure that the voltage, current and hydraulic equivalent values are correct and stable.

• All personnel must leave the equipment before it is ready for operation to ensure personal safety.

• When the slitting machine is running, do not touch the film roll or roller core in operation with your hands, so as not to involve your hands and cause personal injury.

2. Maintenance:

• Clean and lubricate the equipment regularly to ensure that the equipment is in good condition.

• If the equipment is found to have abnormal sound or vibration, it should be stopped immediately for inspection and troubleshooting.

3. Operational Skills:

• Operators should have certain professional skills and be familiar with the performance and operation and maintenance methods of the equipment.

• During operation, do not scratch or cut each roller core with a knife or hard object.

To sum up, the use of the coding ribbon slitting machine includes the preparation before starting, setting the slitting parameters, feeding and film penetration, start-up operation and slitting control, receiving and stopping, and precautions. Correct and standardized operation of the equipment can ensure the safe operation of the equipment and the quality of product slitting.