How to use the slitting machine

The use of the slitter varies depending on the model and purpose, but the following is a basic operation process for reference:

1. Start-up preparation

1. Check the device: Make sure the power cord of the slitter is firmly connected and the power switch is off. Check that the tool is properly assembled, whether the tool is badly worn, and if necessary, replace or sharpen the tool. At the same time, clean the work surface and slitting machine surface to ensure the safety of operation.

2. Wear protective equipment: In order to protect the personal safety of operators, protective glasses and gloves should be worn.

2. Set parameters and feeding

1. Adjust the parameters: Adjust the parameters of the slitting machine according to the slitting plan or production requirements, including cutting speed, tool speed, winding tension, etc., to ensure that the cutting quality can meet the requirements of the workpiece.

2. Feeding: According to the requirements of the slitting schedule, place the coil to be slipped (such as plastic film, paper, metal foil, etc.) on the working surface of the slitting machine, and fix it on the workbench by fixing screws or clamping devices. Make sure the coil is flat and wrinkle-free, and adjust the direction of the coil.

3. Start slitting

1. Start the device: Turn on the power switch of the slitting machine, and after the mechanical system is running normally, use the remote control or button to start the slitting process.

2. Monitor the operation: During the slitting process, the operator should closely monitor the operation status and slitting effect of the equipment. If any abnormalities are found (such as poor cutting quality, abnormal sound of equipment, etc.), the machine should be stopped immediately for inspection and treatment.

4. Rewinding and unloading

1. Rewinding: When the coil is cut into the required size, it is wound into smaller rolls by the winding device. During the winding process, the winding tension and speed should be adjusted to ensure that the coil is wound tightly and neatly.

2. Unloading: When the winding is completed, turn off the power switch of the slitting machine, and wait for the equipment to stop running completely, and then carry out the unloading operation. The rolled coil is removed from the winding device and subjected to the necessary inspection and finishing.

5. Equipment maintenance and maintenance

1. Clean the equipment: After each use, the slitting machine should be cleaned to remove residual coils, debris and other debris.

2. Check the knives: Regularly check the wear and tear of the knives, if the wear is serious, the knives should be replaced or sharpened in time.

3. Lubrication and maintenance: lubricate and maintain the transmission parts of the slitting machine to ensure that the equipment runs flexibly and smoothly.

6. Safety precautions

1. No touching: During the slitting process, it is forbidden to put your hands or other tools into the cutting area to avoid danger.

2. Keep it tidy: Keep the work area tidy and tidy to avoid accidental injuries caused by the accumulation of debris.

3. Emergency stop: If the equipment is abnormal or emergency, the emergency stop button should be pressed immediately and the machine should be stopped.

Please note that the above is only the basic use of the slitter. In actual operation, it should be operated according to the model and instruction manual of the specific equipment. At the same time, operators should receive professional training and be familiar with the operating specifications and safety precautions of the equipment.