How to clean the slitter and reel after slitting?

Cleaning the slitter as well as the reel after slitting is an important step to ensure the normal operation of the equipment and extend the service life. Here are some recommended cleanup steps and considerations:

First, clean the slitting machine

1. Power outage:

• Always disconnect the power supply from the slitter before any clean-up work to ensure that the equipment is in a safe state.

2. Clean up the waste:

• Use tools such as brooms, vacuums, etc. to clean up large pieces of waste from the slitter.

• Meticulously wipe down fine scrap and dust around critical components such as blades and rails.

3. Inspect and clean the fixture:

• Inspect the fixture for residue and, if necessary, clean it up with appropriate tools.

4. Lubrication and maintenance:

• After the cleaning is completed, lubricate and maintain the sliding parts and friction surfaces of the equipment, and fill an appropriate amount of lubricating oil.

5. Fastener Inspection:

• Check whether the fasteners of the equipment are loose, and if they are loose, tighten them in time to ensure the stability of the equipment.

6. Local inspection of electrical appliances:

• Regularly clean and inspect the electrical parts, remove hidden dangers in time, and ensure the safe operation of the equipment.

Second, clean up the scrolls

1. Remove the scroll:

• Remove the reels from the device before cleaning them for a more thorough cleanup.

2. Clean the surface:

• Use a clean cloth or brush to clean the surface of the reel from dust and debris.

• If necessary, it can be cleaned with an appropriate detergent, but care should be taken that the detergent does not cause corrosion or damage to the reels.

3. Check for wear and tear:

• During the cleaning process, check the reels for wear and tear. If it is found that the wear is serious, it should be replaced in time to avoid affecting the quality of slitting.

4. Lubrication and maintenance:

• After cleaning, lubricate the reels to reduce friction and wear.

Third, precautions

1. Safety first:

• Always make sure the unit is powered off and in a safe state before doing any cleanup work.

• Wear appropriate protective equipment such as gloves, goggles, etc., to prevent injury.

2. Clean up regularly:

• Develop a regular cleaning plan to ensure that equipment is always clean and in good condition.

• During the cleaning process, pay attention to check whether the various parts of the equipment are operating normally, and repair or replace them in time if there is any abnormality.

3. Professional Maintenance:

• For some complex or delicate slitting machines and reels, it is recommended to be maintained and cleaned by professionals.

To sum up, cleaning the slitter and reel is an important step to ensure the normal operation and longevity of the equipment. By following the above-mentioned cleaning steps and precautions, it is possible to effectively keep the device clean and in good condition.