Knowledge of operation and maintenance of slitting machine

With the increasing degree of mechanization, the requirements for the efficiency of winding operations are also getting higher and higher. When the slitting machine is used in the slitting operation of film, tape and paper, the whole roll of large reel can be slitted into multiple small reel reels according to different requirements to meet the needs of different occasions, and has a wide range of applications in the die-cutting and coating industry. The following editor shares the knowledge of the operation and maintenance of the slitting machine:

First, he application range of the slitting machine:

1. Used for slitting paper types, which is also the mainstream product in the current packaging equipment, and the packaging market is often visible.

2. It is used in the industries that demand slitting leather, cloth, plastics, films, etc.

3. Used for slitting metal coils such as slitting strip steel, stainless steel, copper... It is mainly used in steel processing plants, steel market operators, steel rolling mills, electrical industry, automobiles, stamping parts and so on.

Second, precautions for operation:

1. During the use process, we should pay attention to whether the parts are operating normally, whether there is any abnormal sound, and stop the machine in time once it appears, find out the cause and eliminate it;

2. Ultrasonic correction, center the material in manual mode before starting, and check whether the correction controller is in automatic mode before starting.

3. Slowly speed up and look at the upper and lower knives when turning on the machine. The gap should not be too large, too large will have burrs, and too small will damage the blade.

4. When calibrating the knife, when the upper knife is put down, the upper knife holder should be locked when the distance from the lower knife is 2~3mm, and the upper knife holder should be placed in the middle of the lower knife groove to avoid the upper knife edge touching the lower knife. When calibrating the knife, the upper knife holder must be locked tightly to avoid the loosening of the upper knife holder and the skipping knife during slitting.

5. Note: The machine should be grounded before use to prevent electric shock.

Third, daily maintenance:

1. Refuel the screw oil filling hole once a day to remove foreign objects, dust and wipe oil on the screw, blade, tool holder, tool holder and sliding guide pillar.

2. Regularly lubricate the transmission chain and gear once every half month, and check the screws to prevent loosening and damaging the machine.

3. Regularly check whether the chain and transmission belt are loose every month.

4. When the laminating and drawing roller does not work, the high position should be mentioned and not pressed on the active rubber roller, so as not to deform. When cleaning the paper laminating rubber roller, it is cleaned with a neutral detergent, and cannot be scrubbed with gasoline, rosin, etc. to prevent premature aging.

5. When not working, the surface of the machine should be scrubbed with a towel or soft cloth to keep the machine clean and clean.

6. When the machine is idle, the screw rod, blade, tool holder, etc. are oil-sealed, and the electroplating parts are rubbed with oil to prevent rust.